To 'safely' re-program a channel, clear the channel of existing data first.The repeater offset and the offset direction are unnecessary. A memory channel for a repeater need only store the receive and transmit frequencies and the transmit CTCSS tone.The radio will receive on the original frequency but transmit on the frequency you entered second. A simplex frequency stored in a channel will not be over-written when you store a different frequency in the same memory channel.In practical terms, this means three things: (CTTCS, Repeater Offset and direction, etc) for both of them. It's useful to remember when programming data into a channel: Each memory channel can store two frequencies and the parameters Although this is a bit tricky, it only has to be done once and becomes reasonably intuitive after a while. ![]() ![]() To program some (or all) of the radio's 128 memory channels. Parameters for repeater operation: transmit CTCSS tone, input/output frequency offset, the direction (- or +) of the offset etc. As it's designed for commercial and PMR use in addition toĪmateur radio, there's nothing to stop it from transmitting outside of any particular band so care needs to be taken when programming the transmitĪlthough the radio can be used by entering frequencies directly from the numerical keypad, it becomes a pain when you need to enter the This little dual band (plus Broadcast Band) transceiver is amazing value for money.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |